Technical parameters and installation steps of the vibrating plate?

Issuing time:2019-04-01 00:00

When the speed-adjusting vibrating plate is installed by cold pressing method, firstly, the pressing tool should be cleaned, a small amount of lubricating oil is applied on the bearing mating surface, and then the pressure tool is evenly pressed on the inner ring of the bearing to smoothly press the bearing. Enter the bearing mating surface of the shaft. It is not allowed to hit the outer ring of the bearing with a hammer during press-fit to prevent the accuracy of the bearing from being lowered.

After the bearing is installed, check whether the bearing rotation is flexible. The inner hole of the bearing should coincide with the center line of the shaft to prevent the bearing from being biased or fractured due to the skew of the center line.

Installation of the vibrating plate:

1. Check whether the whole machine and accompanying accessories meet the packing list when packing.

2. Check if the firmware of each part of the host is loose.

3. It is necessary to make the damping element in the corresponding position during installation.

4. After the height and level of the vibrating plate are adjusted, the base is fixed on the fixed plate or bracket.

5. It is necessary to leave a proper gap between the exit of the vibrating plate and the connected equipment, so as not to affect the normal operation of the vibrating plate.

6. Connect the electrical plug of the vibrating plate with the electrical control box, turn on the power, turn on the switch, and slowly turn the potentiometer.

Gradually reach the required amount of feed. The last thing to note is that the potentiometer must be adjusted to the lowest value before starting the machine to avoid damage to the thyristor.

Home   |   About us   |   Application  |   Solution   |   Products |   Contact us
Tel:+0086-769-83127032   Fax:+0086-769-83127082